Answer
May 03, 2023 - 09:20 AM
Yes,Application Methods Apply between 50° - 90° F on a warm dry surface. Surface temperature must be 5°F higher than the dew point and rising. • Brush: Nylon/polyester • Roller: ⅜" - ½" nap nylon/polyester • Sprayer: Always use airless equipment. Airless sprayer specs must meet or fall between the parameters displayed below. • Minimum Sprayer Requirements – Tip Orifice Size: 0.015, Flow Rate (GPM): 0.34, Maximum Working Pressure (PSI): 3,000, Hose Size: 1/4 inch • Maximum Sprayer Requirements – Tip Orifice Size: 0.065, Maximum Flow Rate (GPM): 4.0, Maximum Working Pressure (PSI): 4,000, Hose Size: 3/8 inch reduced to 1/4 inch o Application Instructions Review product Application Guide before proceeding. Contact Ames Research Laboratories Technical Service Department for questions pertaining to the coating system application and required coating film thickness. Conduct a test patch to ensure proper adhesion. • Blue Max must be top coated with a high-quality acrylic paint for all exterior vertical wall exposures. On interior wall surfaces, Blue Max must be top coated with a high-quality acrylic paint for washability • Blue Max used as a base coat on roofs must be top coated with an appropriate Ames topcoat • Do not apply if the temperature is expected to drop below 32° F within 24 hours of application or over wet substrates • Do not apply in high heat areas of 180°F or more Disclaimer The information and specifications set forth in this Technical Data https://amesresearch.com/content/TDS2...
Add New Comment