Please explain more! How does this adapter give power to the trailer lights?
Liteswich 2.0 Camper/RV Outside Lighting System
Question ID: 3879881 Status:
Open Jan 11, 2022 - 12:27 PM
Answer this question
Jan 11, 2022 - 01:55 PM
Liteswich allows you switch on the marker, clearance and taillights of your camper that can normally only be turned on when the camper is plugged in to your truck. Your camper doesn't come with the ability to turn these lights on you need Liteswich to do it! Foolproof connection - uses the 7 pin wiring connection you normally plug in to your truck. Will ONLY work with campers that have a 7 pin connection. After you set up your camper just plug in the Liteswich . Switch the power switch and on come your lights including the amber and red lights on the front, side and rear. Uses the 12v power from your camper (uses the battery if not plugged into shore power) to power the lights. Liteswich switches on your marker, clearance, and taillights of your camper or RV that normally can only be controlled while plugged into your truck. Uses 12V power from your camper (uses the battery if not plugged into shore power), to power your lights. Uses the same 7-pin wiring connection you would use to plug into your truck. Note: Will only work with campers/RVs with a 7-pin connection.
Feb 15, 2022 - 07:03 AM
It's just a jumper of two wires the +pos battery and the marker lights. You could do the same with a piece of 14ga wire if you know which two pins to connect.
Other Questions Needing Answers