Answer
May 08, 2021 - 04:29 AM
This step is used when a sensor is to be removed from the memory of the monitor or to remove a sensor from one position and locate it to a different position.
To enter into the Delete Sensor Location Programming Mode from the Normal Operation screen, press and hold the “P” button for 5 seconds until the “PROGRAM” screen is displayed. Then press the “P” button four times to access the Delete Sensor Location Programming Mode (See Figure Below).
![]()
In the Delete Sensor Location Programming Mode, all programmed sensors will be displayed. If no sensors need to be deleted, proceed to the next screen by pressing the “P” button once. To delete a sensor, select the sensor using the arrow buttons (Figure Below).
Hold down the “S” button until the three digits blink and audible beeps are heard. The sensor will now be removed (Figure Below).
When all desired sensors are deleted, proceed to the High Pressure Alarm Programming Mode by pressing the “P” button once.
To program a deleted sensor to a different location, or add new sensors to the monitor’s memory, press the “P” button twice to enter into the Programming Sensor Location mode.
To enter into the Delete Sensor Location Programming Mode from the Normal Operation screen, press and hold the “P” button for 5 seconds until the “PROGRAM” screen is displayed. Then press the “P” button four times to access the Delete Sensor Location Programming Mode (See Figure Below).
In the Delete Sensor Location Programming Mode, all programmed sensors will be displayed. If no sensors need to be deleted, proceed to the next screen by pressing the “P” button once. To delete a sensor, select the sensor using the arrow buttons (Figure Below).
Hold down the “S” button until the three digits blink and audible beeps are heard. The sensor will now be removed (Figure Below).
When all desired sensors are deleted, proceed to the High Pressure Alarm Programming Mode by pressing the “P” button once.
To program a deleted sensor to a different location, or add new sensors to the monitor’s memory, press the “P” button twice to enter into the Programming Sensor Location mode.
Add New Comment