Is there any programming involved. Or just remove the old one and replace with the new one. They are identical.
Garnet 710ES SeeLevel II Sensor Board - 12''
RV Tank Monitor System
Question ID: 3552363 Status:
Open Feb 22, 2021 - 01:27 PM
1answer
Answer
Feb 23, 2021 - 08:54 AM
Changing out a Garnet 710ES sensor board does not require any programming. Depending on what tank the sensor is going on will determine what tab on top of the sensor should be cut. If the sensor is going on a fresh tank, then no tab would need to be cut. If the sensor is going on a grey tank then the gray tab on top of sensor should be cut, and if it’s the black tank then the black tab will need to be cut. THis is the only programming that is done prior to adhering the sensor to the tank.
Answer this question
View More Product Details
Garnet 710ES SeeLevel II Sensor Board - 12''
The Garnet SeeLevel II Sensor Board is a flexible self adhesive printed circuit board which is mounted to the outside of your holding tanks. The sender can be cut to length to match the height of your tanks, or tanks over 12 inches may be double stacked.
View Product
View all RV Tank Monitor System Questions & Answers
View all Garnet 710ES SeeLevel II Sensor Board - 12'' Questions & Answers
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
Add New Comment