Answer
Aug 17, 2020 - 06:08 AM
The Garnet SeeLevel units are not vehicle specific but you would have to check and make sure your Jayco meets the requirements as listed on our product page.
Display Mounting Panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.
System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.
Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.
Pump Switch: The pump and heater switch is rated for a maximum of 6 amps. A relay is required if more than 6 amps is needed. A 7.5 amp fuse is included.
Add New Comment