Answer
Mar 26, 2020 - 03:59 AM
For an F24 it can be 1 of 2 things below. I have also included a link to the manual where this info is so if you need other help they have a lot of troubleshooting.
Too much laundry for a program/cycle with a small maximum load. Solution: Select and start the Rinse & Spin program to complete the interrupted wash program/cycle. Do not overload the washer. Follow the maximum load size indicated in the “Program/Cycle Guide” section.
Too much inlet water. Solution: Turn off the water faucet. Touch and hold the Power button for at least 3 seconds to drain the water; wait until the drain phase has ended (End will appear on the display). Turn on the water faucet again. If water immediately flows into the washer without a program/cycle being started, an electrical component has failed. Close the water faucet, turn off and unplug the washer. See the “Assistance or Service” section to contact a service representative.
Too much inlet water. Solution: Turn off the water faucet. Touch and hold the Power button for at least 3 seconds to drain the water; wait until the drain phase has ended (End will appear on the display). Turn on the water faucet again. If water immediately flows into the washer without a program/cycle being started, an electrical component has failed. Close the water faucet, turn off and unplug the washer. See the “Assistance or Service” section to contact a service representative.
Add New Comment