Answer
Apr 22, 2019 - 06:01 AM
Below is a link to the instruction manual for the 20195VA back up sensor. Sensors are not powered by batteries, below is the instructions for installation of the sensors
https://www.rvupgradestore.com/v/vspf...
Rear Sensors Installation: 1. Measure the width of your bumper and divide by 3. This will identify possible mounting locations for the sensors. Make sure you have at least 24” between the sensors. Sensors should also be approximately 2 feet above the ground. 2. OPTION 1: If you want to conceal the wire, you will need to drill (drill bit size 7/16”) a small hole in your bumper for each sensor to allow the wire to pass through. When drilling, be careful to avoid any critical visual or operating components of the vehicle. OPTION 2: There is a cut away in the top of the sensor where wire comes out. Remove the plastic in the cut away. Insert wires into cut away. This allows you to avoid drilling a hole in your bumper. The wires will run over your bumper to the control box. 3. Plug the wire from the sensor into the ECU. Plug the right hand sensor in “#3” (Passenger Side) and the left hand sensor in “#2” (Driver Side) on the control unit. Remove the film on the adhesive tape and mount sensors to bumper. Note: If sensors are not working correctly “E2” (driver side) or “E3” (passenger side) will display on monitor.
https://www.rvupgradestore.com/v/vspf...
Rear Sensors Installation: 1. Measure the width of your bumper and divide by 3. This will identify possible mounting locations for the sensors. Make sure you have at least 24” between the sensors. Sensors should also be approximately 2 feet above the ground. 2. OPTION 1: If you want to conceal the wire, you will need to drill (drill bit size 7/16”) a small hole in your bumper for each sensor to allow the wire to pass through. When drilling, be careful to avoid any critical visual or operating components of the vehicle. OPTION 2: There is a cut away in the top of the sensor where wire comes out. Remove the plastic in the cut away. Insert wires into cut away. This allows you to avoid drilling a hole in your bumper. The wires will run over your bumper to the control box. 3. Plug the wire from the sensor into the ECU. Plug the right hand sensor in “#3” (Passenger Side) and the left hand sensor in “#2” (Driver Side) on the control unit. Remove the film on the adhesive tape and mount sensors to bumper. Note: If sensors are not working correctly “E2” (driver side) or “E3” (passenger side) will display on monitor.
Add New Comment