Answer
Feb 12, 2019 - 07:41 AM
The sensor would not really work accurately if you put it at an angle. The best way you would be able to do it is monitor the 7" section with one of the 710JS sensors. The top would need to be left alone.
Would sensor function if applied to tank at an angle on 3" tank section? Garnet 710JS Seelevel II Junior Sensor Board - 6'' RV Tank Monitor System
I have a gray water tank that has a 7 inch vertical side and then tiers out to another 3 inch high section. This is where it hangs on a bracket, the shortest SeeLevel sensor board can only be trimmed down to 4 inches, so I'm wondering if it can be applied on an angle so the left side of the sensor is flush against the tank and monitors that section. Any other suggestions would be helpful. Thank You-Kyle
Question ID: 2626988 Status:
Open Feb 11, 2019 - 10:25 AM
Do you have the same question? Follow this Question
1answer
View More Product Details
Garnet 710JS Seelevel II Junior Sensor Board - 6''
The Seelevel II 710JS Junior Sensor Board is a flexible self adhesive printed circuit board which is mounted to the outside of your holding tanks. The sender can be cut to length to match the height of the tank. Provides more accurate level readings on tanks that are less than 7 inches in height.
View Product
Browse by Category
RV Tank Monitor System
View our complete selection of RV Tank Monitor System to find the one that suites your needs.
View All
View all RV Tank Monitor System Questions & Answers
View all Garnet 710JS Seelevel II Junior Sensor Board - 6'' Questions & Answers
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
Add New Comment