Answer
Jan 14, 2019 - 03:04 AM
Did the resin you bought work for the first cycle that you used it? If not, what are you using to test the hardness of the water? The special regeneration process is as follows:
Step 1: Turn off the water supply.
Step 2: Disconnect outlet hose from the outlet side of the softener.
Step 3: You can drain water by tilting unit over or turning it upside down with the head/cap ON. Once draining has been completed, flip the unit back upright and tap the black base against the ground a few times to get the resin to fall back down into the bottom of the tank.
Step 4: Remove the top cap.
Step 5: Add 2 26oz boxes of table salt (mix salt with warm water and pour the solution into the softener if the water has been drained out)
Step 6: Put the top cap back on and slow rinse the unit for 25-30 minutes
Step 7: Fast rinse for 5 minutes
Step 8: Check the hardness at the output of the softener
Step 1: Turn off the water supply.
Step 2: Disconnect outlet hose from the outlet side of the softener.
Step 3: You can drain water by tilting unit over or turning it upside down with the head/cap ON. Once draining has been completed, flip the unit back upright and tap the black base against the ground a few times to get the resin to fall back down into the bottom of the tank.
Step 4: Remove the top cap.
Step 5: Add 2 26oz boxes of table salt (mix salt with warm water and pour the solution into the softener if the water has been drained out)
Step 6: Put the top cap back on and slow rinse the unit for 25-30 minutes
Step 7: Fast rinse for 5 minutes
Step 8: Check the hardness at the output of the softener
Add New Comment