How to test the 710ES Seelevel II sensor board?
Garnet 710ES SeeLevel II Sensor Board - 12''
RV Tank Monitor System
my fresh tank reads Opn My black and gray work just fine as did my fresh until today. Can I use an ohm meter to test the board. I already went over my wiring.
Question ID: 2426067 Status:
Open Mar 23, 2018 - 04:46 PM
Electronics > Seelevel Tank Monitoring System
1answer
Answer
Mar 27, 2018 - 03:48 AM
You can use a volt meter to check the continuity of the signal wire running from the sender to the monitor. I would recommend shorting the blue wire at the sender to ground first. Once shorted, the display should read “Sht” indicating a short circuit. If the display show the short error message then the problem is most likely with the sender.
How long have you had the system?
Answer this question
View More Product Details
Garnet 710ES SeeLevel II Sensor Board - 12''
The Garnet SeeLevel II Sensor Board is a flexible self adhesive printed circuit board which is mounted to the outside of your holding tanks. The sender can be cut to length to match the height of your tanks, or tanks over 12 inches may be double stacked.
View Product
View all RV Tank Monitor System Questions & Answers
View all Garnet 710ES SeeLevel II Sensor Board - 12'' Questions & Answers
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
Add New Comment