Answers
May 03, 2017 - 02:40 AM
We looked at the Mopar 82210214-AB wiring setup for your Jeep and this brake control wiring harness will not work. You would need to use universal wiring, which many brake controllers come with the universal wiring. Because we don't know what brake controller you are using, below is a link to an example for general wiring. Hope this helps and if you have any other questions, feel free to ask.
https://www.rvupgradestore.com/v/vspf...
https://www.rvupgradestore.com/v/vspf...
May 03, 2017 - 03:18 AM
To clarify, yes you would need to use a universal wiring harness that has one connector and bare wires on the other end.
By
Thank you for checking into my question. To clarify my question, I was asking if there were any of the 2 plug Tekonsha wiring assemblies available through you that would "plug and play" connect a Prodigy P2 or P3 brake controller to the factory Mopar 7 pin harness # 82210214AB on the 2014 Jeep JKU Wrangler. I was only using the Tekonsha part numbers of 3045-P, 3020, 3016 as examples of "plug and play" harnesses designed for use to connect the P2 or P3 in other vehicles such as the Jeep Grand Cherokee, Jeep Trail Hawk, GMC and other pick up trucks, etc.
If you could clarify your reply, did you mean that there are no JKU Wrangler "plug and play" Tekonsha harnesses available for the 2014 Jeep JKU Wrangler?
Did your reference to "universal wiring" mean that all that is available for the P2 and P3 controllers is the wiring with only one quick connector (the brake controller connecting end) and bare wire ends to allow crimping or soldered connections to the Jeep factory wiring system?
Thank you for any additional info you can offer on my goal of purchasing supplies to allow me to most easily connect a brake controller into the 2014 JKU Wrangler.
Add New Comment