Answer
Jun 27, 2016 - 05:27 AM
Tip the unit slightly and allow a few cups of water to drain out the inlet side of the tank head. Remove the fill port (never remove the tank head) and pour commmon table salt into the unit.
Here are the complete regeneration instructions:
Regeneration
Here are the complete regeneration instructions:
Regeneration
- Close the inlet and outlet valves and connect a garden hose to the drain port of the Y valve. Open the drain valve to relieve any pressure in the system.
- Once the pressure is relieved close the drain valve port and remove the system from the RV.
- Gently tilt the system to drain some water out of the mineral tank to create room for salt.
- Once a few cups of water have been drained from the system, remove the tank head fill port, and pour 2 lbs of sodium chloride table salt into the fill port on the head. Use a cup of water to rinse the fill hole clean of salt crystals and reinsert the fill plug.
- Allow the unit to set for 5 minutes, then turn on the inlet valve and open the drain port on the Y valve to begin the brine rinse process.
- After 20 minutes of brine rinsing the system is ready to be installed back into the RV and is ready for use.
- Regeneration should be performed when the hardness from your system exceeds 3 grains per gallon as indicated on the supplied water test strips.
Add New Comment