connecting hydrolic hoses back to fitting
Hello I have an Lippert Hydrolic pump and I have to hook it back up and I forgot to mark the hoses for the correct fitting, can you direct me on which hose goes to the correct fitting?
Thanks
Lloyd
Question ID: 1794936 Status:
Open Oct 20, 2015 - 10:27 AM
Lippert Repair Parts > Hydraulic Slide-Out Pumps and Parts
2answers
Answers
Oct 20, 2015 - 10:42 AM
On the Hydraulic pump there is a fitting marked "E" this is the extend side of the pump. Your hydraulic hose should have this marked on it. If it does not, hook both hoses to pump and push slide-out switch momentarily in or out depending on how your slides are currently. If they are doing the opposite of the switch, reverse the connections.
Oct 29, 2015 - 04:40 PM
You do not need to bleed the hoses. You need to run the slide in and out with the slide control switch and the air will purge out of the system. The tank should be 3/4 full
Answer this question
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
By
Hello I have a quick question, Do I have to bleed my hydraulic hoses when they are disconnected? it was working fine and now my slide out does not want to retract.. I think I have plenty of hydraulic fluid but I could be wrong, is there a max and min fill line on the reservior that could indicate that? if so could you please tell me where to look, because I can't see one no where...
Thanks for your time and help on this matter,
Lloyd L. Ellis
Add New Comment