Answer
Aug 23, 2015 - 09:48 PM
The Bauer NE Operation & Program Guide Description The Bauer NE is a 4 touch pad button programmable deadbolt lock. The 4 buttons are labeled 1|2, 3|4, 5|6, 7|8. The button labeled 1|2 is the same button whether the number 1 or 2 is desired. Please note this handle uses Touch Technology. The buttons are activated by Touch and does not require pressing the buttons. Touch the button and lift finger from button for proper code entry. Operation The Bauer NE incorporates proximity sensing to determine when you want to activate the lock. To operate the lock you first must wake up the lock. To wake up the lock you must touch the area next to the buttons. The buttons will illuminate once the Touch Pad is wakened. This indicates that the Touch Pad is ready for the code to be entered. Preset Factory Code The Bauer NE has a factory set code of 3,7,1,5 followed by the Enter button. The button with the is the Enter button, and is required to be touched after the code is entered. The factory code resets every time the batteries are removed for at least 10 seconds. Programming New Code To set a new code, touch and hold the 3|4 button and the Enter Buttons for 2 seconds. The Bauer NE will provide three short beeps, indicating it is ready to accept a new code. Enter the new 4 digit code followed by the The Bauer NE will provide four short beeps to indicate new code has been entered. The first time the new 4 digit code is entered there will be a long beep indicating the new code is accepted. The new code can be entered now and will activate the dead bolt. To reset the code, remove the batteries for at least 10 seconds. Re-install the batteries; and follow the steps to Programming New Code. Please Enter Personal Code upon Installation of Lock to prevent inadvertent
Add New Comment